Software Installation

Below are a detailed steps, about how to update the MicroBox dongle.

Step 1:

- Connect the MicroBox dongle to the power, and make sure its turned on ( Red light inside it ), after that connect the serial port from the MicroBox to the serial port, in your PC.

Step 2:

- Download the cleaner software for the downloads section, then open the .rar file and you should be able to see the below files, open the cleaner.exe file.

 

- After you have the program opened click START button, then you should see that a "Waiting Boot..." is showing up near the software title, as the below image shows.

 

- Now unplug the power cable from the dongle for 2 seconds then plug it again, into the MicroBox, after that you should be able to see the progress bar increasing and the cleaning process is started, as the below image shows.

 

  s reaches 100%, you are good so far, unplug it again from the power for 2 seconds then plug it again.

Step 6:

- Now download the software that you want to install from the site, then open the .rar file as below.

is the software it self.

Step 8:

- After you have the program opened click START button, then you should see that a "Waiting Boot..." is showing up near the software title, as the below image shows.

- Now unplug the power cable from the dongle for 2 seconds then plug it again, into the MicroBox, after that you should be able to see the progress bar increasing and the transferring process is started, as the below image shows.

- Once the transfering process reaches 100%, you are good so far, unplug it again from the power for 2 seconds then plug it again, and by this you have the software installed at your MicroBox Dongle.

Hope this was useful for you.